Posts Tagged ‘PTFE’

1/2” AODD pump with multiple mounting orientations

Friday, November 16th, 2018 von admin

The new V150 13 mm (1/2”) Velocity Series pump from Wilden is featuring a detachable mounting foot. It can easily be reoriented into a vertical or horizontal position with multiple inlet and discharge port options. With this innovative design, the pump can be installed in multiple orientations, a critical consideration for systems and skids.

The Velocity Series – available in 13 mm (1/2”) and 6 mm (1/4”) sizes – features a bore-seal design that eliminates leaks that can result from torque decay. It also delivers improved dry suction lift up to 4.3 m (14.2’) in the 6 mm (1/4”) size and 5.1 m (16.9’) in the 13 mm (1/2”) size better priming. In addition, these pumps incorporate a proven and simple air distribution system (ADS) with only two moving parts that reduces the risk of downtime for long-term reliability.

(more…)

AODD pumps with a solid plastic design

Friday, July 20th, 2018 von admin

The new C-Series pumps have been specifically developed by Almatec to be a cost-effective alternative. The housing parts are tightened to each other via housing bolts. All of the C-Series’ bolts are tightened together against a diaphragm-sized ring on each side of the pump.

This design distributes the forces of the housing bolts onto the housing parts evenly, providing a consistent flow of forces that increases bolt torque and improves pump safety.

(more…)

Elbow pump made from plastic

Monday, June 18th, 2018 von admin

The use of elbow pumps is always indicated when large flow rates are to be pumped to low heads. This requires a propeller-like impeller with both axial inlet and outlet, which guides the out warding flow into a pipe bend. This geometry then allows the introduction of a long projecting pump shaft in the pipe bend up to the impeller. The bearing of the pump shaft takes place outside the pumping chamber and must be generously dimensioned in the axial direction. The adjustment of the delivery head is usually done with a belt drive between the pump shaft and motor. The new ROPP model – showcased at Achema 2018 – of the Germany based pump manufacturer Wernert is also based on this classic pump concept, but with a few additional technical features that should be of interest to the experts and pump users in the chemical industries:

Richter named most valuable supplier by Wanhua Chemical Group

Tuesday, January 17th, 2017 von admin

Richter Chemie-Technik GmbH, a leading manufacturer of fluoropolymer lined pumps and valves, has been awarded by Wanhua Chemical Group, as one of its most promising suppliers of the year.

Over the past years Wanhua Chemical Group, the world’s largest producer of MDI (Methylene diphenyl diisocyanate) has been experiencing rapid domestic and global growth. As one of Wanhua’s top suppliers for critical equipment for more than 10 years, Richter’s global presence has contributed to the expansion of Wanhua with pumps and valves for the most corrosive applications. Reliable quality and top notch service have been key to our long standing cooperation.

(more…)