Posts Tagged ‘bearing’

Inpro: Bearing Isolator for Pumps

Tuesday, March 7th, 2017 von admin

The Bearing Isolator extends bearing life by increasing protection against contamination ingress and lubrication loss. The original Bearing Isolator, a simple two-piece design, consisted of a rotor and stator interface to keep contaminants from entering the bearing housing. Now, the next generation of Bearing Isolators has been presented.

The VB45-S Bearing Isolator utilizes a patented XX Interface coupled with an enlarged contamination chamber to achieve an IP66 rating, the standard for ingress protection against both harmful dust particulates and powerful water jets from all directions. For superior protection against lubrication loss, the VB45-S utilizes an enlarged D-Groove to capture oil and return it back to the bearing housing or a grease band to block grease from traveling down the shaft and escaping from the bearing housing.
(more…)

Durit: Increasing wear protection, reducing maintenance costs

Thursday, June 25th, 2015 von admin

DuritImage_2015_04Pumping of abrasive slurry or chemical reagents demand for maximum efficiency and work pace increasing wear of the applied components and thus all associated maintenance costs in pump technology as well. More and more frequently, seal and packing rings of pumps are made of ttungsten carbide – a sinter material. Additional fields of application for tungsten carbide components in pump engineering include

  • rotors,
  • control elements,
  • bearing sleeves,
  • plain bearings,
  • and hubs,

which are exposed to abrasive media.
(more…)

Waukesha: Tilt pad thrust bearings for up to 300 °C

Tuesday, October 14th, 2014 von admin

WB_HidraxHTThe new Hidrax™ HT thrust bearings are developed for high-temperature applications in electric submersible pumps. These pad bearings can sustain unit loads of 8 MPa (1160 psi) at oil bath temperatures up to 300°C (572°F).

Technological advances in steam-assisted gravity drainage are increasing operating temperatures and placing increased demands on the thrust bearings located in the motor seal/protector section of the electric submersible pumps string.

(more…)

Inpro/Seal: Intelligence in Shaft Grounding

Monday, August 18th, 2014 von admin

The Smart CDR is an condition monitoring system that provides users with instant feedback on the performance of their Current Diverter Ring® (CDR) in diverting shaft currents away from bearings to ground.

(more…)